2.b Amal Remote Needle (RN) Carburettor Parts

2.b Amal Remote Needle (RN) Carburettor Parts

2.b Amal Remote Needle (RN) Carburettor Parts
Amal Remote Needle Parts (RN)

Display per page
Sort by

Castrol ValveMaster Plus - Lead Replacement Plus Octane Booster - 250ml Bottle

Product no.: 0614 Castrol2

Castrol ValveMaster Plus - Lead Replacement Plus Octane Booster - 250ml Bottle

£13.00 *
In stock
can be shipped within 30 days

TT (and RN) Float Chamber Twin Banjo

Product no.: 0159 14/251B
- Banjo to fit TT and RN competition carburettors
£25.00 *
In stock

TT (and RN) Float Chamber Banjo Nut

Product no.: 0160 14/255

- Banjo Nut to fit TT and RN competition carburettors. - As per original, including the hole at the bottom for lockwiring - Note: this type of banjo was also used on the later Type 302 floatchamber, used on later RN and GP1 carburettors. On these floatchambers the banjo was normally fitted on the top. (see also the GP section for other Type 302 parts)

£14.00 *
In stock
can be shipped within 15 days

Amal RN Parts - Information Section

Product no.: 0166 Info4b
Listed here are reproduction parts to fit Amal Remote Needle (RN) carburettors. These carburettors were fitted to the racing versions of SOHC (Manx) Nortons from the late 1930's, through to about 1951 when they were replaced with the fitting of the GP1. In Amals racing evolution, these carburettors were like an interim version of the GP carb, in so much that Amal had realised it would be a good idea to move the needle away from the choke area, so as not to obstruct the airflow, so giving the name 'Remote Needle'. In practice, it was found that the route for the fuel flow from the needle was not perfect (so I am led to believe from the literature I have read) and therefore they were more fickle to tune than the more common TT carb. However, they were found to give better results on 'out and out' fast circuits, which presumably the Grand Prix bikes were more likely to encounter. Clearly, Amal's thought they were on the right track, because the GP1 carb was similar in concept, however the fuel routing was improved in design. As a footnote to this, I remember when I started racing in the 1980's that RN carbs were quite common on peoples shelf's because they were considered rubbish for short circuit racing, and no-one wanted them! I certainly remember turning up my nose at a couple of them, even though they were dirt cheap - - - not so now! There seems to be very little information available for Remote Needle carburettor, and the parts specific to RN carburettors are now extremely difficult to find. This section offers some of the parts specific to the RN carb and I am also looking to have many of the other parts made in the future - including the RN specific needle holder that screws onto the side of the TT slide. Please note though, that these parts will be comparably far more expensive than the TT parts, as I am having them made specially in much smaller quantities than the TT parts.
£0.00 *

RN Needle Cap and Prayer Book Spring (sold as a pair)

Product no.: 0167 185/120+106
- These are the 2 components that fit over the top of 'Remote Needle' part of an RN Carb, almost without exception, they are missing when you buy an RN carb! -Apologies for the price, but small volume, high setup cost by my supplier (I have them on my RN'
£23.00 *

RN Needle Jets

Product no.: 0168 185/1xx
RN Needle Jets - Available in 109,113 and 120 (methanol) sizes - Note: these are not the same as TT needle jets, unlike the main jets which are interchangeable with TT main jets
£9.00 *

10 RN Carb Needles

Product no.: 0169 185/119
- Needles to fit Amal RN Carburetter - Very similar to a TT needle (you can actually use a TT, as some of the ring grooves overlap), but with a slightly different length
£12.00 *

500cc TT/RN Carburettor Flange Gasket

Product no.: 0452 A11/727
Paper gasket that fits on flange fitting TT/RN 500cc carburettors. This gasket should be changed each time the carb is removed and refitted. This gasket has a 1 3/16" / 30mm bore hole, suitable for most 500cc SOHC size carburettors
£1.40 *

350cc TT/RN Carburettor Flange Gasket

Product no.: 0453 A10/727
Paper gasket that fits on flange fitting TT/RN 350cc carburettors. This gasket should be changed each time the carb is removed and refitted. This gasket has an approx 1 3/32" / 28mm bore hole, suitable for most 350cc SOHC size carburettors
£1.40 *

TT (Type 14) Floatchamber Float

Product no.: 0458 TT14Float

This is a modern replacement (plastic) float for the Amal TT (and Type 27) carburettor, using the Type 14 and twin bowl float-chamber float and needle clip

£23.00 *

Type 302 Floatchamber Remote Mount Banjo

Product no.: 0292 14/255R

This is the topfeed banjo used on Amal Type 302 floatchambers (used from the late 1940's), that allows them to be remote mounted. This item is drilled and tapped in its centre which provides the means to remote mount them

£13.50 *
In stock
can be shipped within 15 days

TT/RN Air Adjuster Kit

Product no.: 0149 TT/Air

6 part air adjuster kit for both TT and RN carburetters, containing the following parts: - Air cable adjuster and locknut - Air barrel top - Air valve and nipple holder for air valve - Air valve spring.  These also fit RN/GP carbs

£18.00 *
In stock
can be shipped within 90 days

14/024 Float Needle for Amal 276 and early TT Floatchambers

Product no.: 0613 14_024

Brass float needle to fit the Amal 276 type floatchambers and the early (mainly pre-war) type floatchamber.  

£13.00 *
*
Recommended Retail Price, plus delivery